Polarized Ringer.  The polarized bell or ringer is, as has been stated, the device which is adapted to respond to the currents sent out by the magneto generator.  In order that the alternately opposite currents may cause the armature to move alternately in opposite directions, these bells are polarized, i.e., given a definite magnetic set, so to speak; so the effect of the currents in the coils is not to create magnetism in normally neutral iron, but rather to alter the magnetism in iron already magnetized.

Western Electric Ringer. A typical form of polarized bell is shown in Fig. 79, this being the standard bell or ringer of the Western Electric Company.  The two electromagnets are mounted side by side, as shown, by attaching their cores to a yoke piece 1 of soft iron.  This yoke piece also carries the standards 2 upon which the gongs are mounted.  The method of mounting is such that the standards may be adjusted slightly so as to bring the gongs closer to or farther from, the tapper.

The soft iron yoke piece 1 also carries two brass posts 3 which, in turn, carry another yoke 4 of brass.  In this yoke 4 is pivoted, by means of trunnion screws, the armature 5, this extending on each side of the pivot so that its ends lie opposite the free poles of the electromagnets.  From the center of the armature projects the tapper rod carrying the ball or striker which plays between the two gongs.

In order that the armature and cores may be normally polarized, a permanent magnet 6 is secured to the center of the yoke piece 1.  This bends around back of the electromagnets and comes into close proximity to the armature 5.  By this means one end of each of the electromagnet cores is given one polarity—­say north—­while the armature is given the other polarity—­say south.  The two coils of the electromagnet are connected together in series in such a way that current in a given direction will act to produce a north pole in one of the free poles and a south pole in the other.  If it be assumed that the permanent magnet maintains the armature normally of south polarity and that the current through the coils is of such direction as to make the left-hand core north and the right-hand core south, then it is evident that the left-hand end of the armature will be attracted and the right-hand end repelled.  This will throw the tapper rod to the right and sound the right-hand bell.  A reversal in current will obviously produce the opposite effect and cause the tapper to strike the left-hand bell.

An important feature in polarized bells is the adjustment between the armature and the pole pieces.  This is secured in the Western Electric bell by means of the nuts 7, by which the yoke 4 is secured to the standards 3.  By moving these nuts up or down on the standards the armature may be brought closer to or farther from the poles, and the device affords ready means for clamping the parts into any position to which they may have been adjusted.