[Illustration:  Fig. 115.—­Details of stretcher attachment for diamond-shaped box kites.]

Diamond Box Kites.—­In another type of box kite the boxes have four equal sides, but the boxes are rhombus-shaped, as in Fig. 116, the long diagonal being square to the wind, and the bridle attached at the front corner.

For particulars of design and construction I am much indebted to Mr. W. H. Dines, F.R.S., who has used the diamond box kite for his meteorological experiments to carry registering meteorographs several thousands of feet into the air.

The longitudinal sticks used at the corners have the section shown in Fig. 115.  They are about four times as wide at the front edge, which presses against the fabric, as at the back, and their depth is about twice the greater width.  This shape makes it easy to attach the shorter stretchers, which have their ends notched and bound to prevent splitting.

[Illustration:  Fig. 116.—­Plan of diamond box kite, showing arrangement of stretchers.]

Fig. 117 is a perspective diagram of a kite.  The sail of each box measures from top to bottom one-sixth the total circumference of the box, or, to express the matter differently, each face of the box is half as long again as its depth.  The distance separating the boxes is equal to the depth of a box.

The sides of a box make angles of 60 degrees and 120 degrees with one another, the depth of the space enclosed from front to back being the same as the length of a side.  With these angles the effective area of the sails is about six-sevenths of the total area.  Therefore a kite of the dimensions given in Fig. 117 will have an effective area of some thirty square feet.

[Illustration:  Fig. 117.—­Diamond box kite in perspective.  Ties are indicated by fine dotted lines.]

The long stretchers pass through holes in the fabric close to the sticks, and are connected with the sticks by stout twine.  Between stretcher and stick is interposed a wedge-shaped piece of wood (A in Fig. 115), which prevents the stick being drawn out of line.  This method of attachment enables the boxes to be kept tight should the fabric stretch at all—­as generally happens after some use; also it does away with the necessity for calculating the length of the stretchers exactly.

The stretchers are tied together at the crossing points to give support to the longer of the pair.

The dotted lines ab, AC, ad, Em, and en in Fig. 117 indicate ties made with wire or doubled and hemmed strips of the fabric used for the wings.  Ab, running from the top of the front stick to the bottom of the back stick, should be of such a length that, when the kite is stood on a level surface, the front and back sticks make right angles with that surface, being two sides of a rectangle whereof the other two sides are imaginary lines joining the tops and bottoms of the sticks.  This tie prevents the back of the kite drooping under pressure of the wind, and increases the angle of flight.  The other four ties prevent the back sails turning over at the edges and spilling the wind, and also keep them flatter.  This method of support should be applied to the type of kite described in the first section of this chapter.