If the load should increase at such a time the governor could not control it under these conditions, and it would lead to a decrease in speed unless the lap was again changed to give a later cut off.  On this account the general practice soon becomes to leave the cut off at the later point and give range to the throttle, and we come back once more to the plain slide valve cutting off at half stroke, and the only gain there is, is in a quick port opening and quick cut off.  But these matters are more than offset by the wire drawing between the steam pipe and chest, through the throttle, and the fact that there is added to the friction of the engine the friction of this additional slide valve and a considerable liability to have a leaky valve.

In the case where the governor changes the position of the cut off valve a greater decree of economy would result.  In this engine, of which the Lambertville engine is a type, the main valve is a long D slide, with multiple ports at the ends through which the steam enters the cylinders.  It is operated from an eccentric on the crank shaft in the usual manner.  The cut off valve is also operated from the motion on an eccentric fixed upon the crank shaft.  The rod or stem of the cut off valve passes through the main valve rod and slide.  Upon the outer end of the cut off valve rod are tappets fastened to engage with tappets on the eccentric valve rod.  Connection between the cut off eccentric, therefore, and the cut off valve is only by means of the engagement of these tappets.  The eccentric rod is fastened to a rocker arm having motion swinging about a pin or bearing in the governor slide, which may be raised or lowered by a cam operated by the governor.  The cut off slide is of cylindrical shape and incloses a spring and dash pot with disks attached by means of which the valve is closed.  The motion for operating the valves is relatively in the same direction, the cut off eccentric having the greatest throw and greater angular advance to cause it to open earlier and quickly before the main valve is ready to admit steam.  The cut off eccentric rod swinging the rocker arm, the tappets thereon engage with those upon the cut off valve rod and open the passages to the main valve, and in their movement compress the spring in the main valve.  According as the speed of the engine, the rock arm will be raised or lowered so that the tappets upon the eccentric rod may keep in engagement a shorter or longer time before they disengage, thus allowing the spring that has been compressed by the movement of the cut off valve to close that valve quickly and the supply of steam to the engine, the cut off valve traveling with the main valve for the balance of the stroke.  This device will give a remarkably quick opening and a quick cut off, but in view of the fact that the governor has so much to do, its delicacy is impaired and a quick response to the demands of the load changing not so likely to occur.  The cut off cannot be as quick as in some other engines, because the valves are moving in opposite directions, and while this fact would help, so far as shortening the distance to be traveled before cut off, the resistance of the valves to travel in opposite directions, or rather the tendency of the valve to travel with the main valve, hinders its rapid action.