** A Convenient Hot-Dish Holder [7]

When taking hot dishes from the stove, it is very convenient to have holders handy for use.  For this purpose I screwed two screw eyes into the ceiling, one in front of the stove directly above the place where the holder should hang, and the other back of the stove and out of the way.  I next ran a strong cord through the two eyes.  To one end of the cord I attached a weight made of a clean lump of coal.  The cord is just long enough to let the weight hang a few inches above the floor and pass through both screw eyes.  I fastened a small ring to the other end to keep the cord from slipping back by the pull of the weight.  I then fastened two pieces of string to the ring at the end of the cord and attached an iron holder to the end of each string.  The strings should be just long enough to keep the holders just over the stove where they are always

[Illustration:  Holders in a Convenient Place]

ready for use, as the weight always draws them back to place.  —­Contributed by R. S. Merrill, Syracuse, New York.

** Magic-Box Escape [7]

The things required to make this trick are a heavy packing box with cover, one pair of special hinges, one or two hasps for as many padlocks and a small buttonhook, says the Sphinx.

The hinges must be the kind for attaching inside of the box.  If ordinary butts are used, the cover of the box

[Illustration:  Box with Hinges and Lock]

must be cut as much short as the thickness of the end board.  The hinges should have pins that will slip easily through the parts.

Before entering the box the performer conceals the buttonhook on his person, and as soon as the cover is closed and locked, and the box placed in a cabinet or behind a screen, he pushes the pin or bolt of the hinge out far enough to engage the knob end with the buttonhook which is used to pull the pin from the hinge.  Both hinges are treated in this manner and the cover pushed up, allowing the performer to get out and unlock the padlocks with a duplicate key.  The bolts are replaced in the hinges, the box locked and the performer steps out in view.

** A Flour Sifter [7]

When sifting flour in an ordinary sieve I hasten the process and avoid the disagreeable necessity of keeping my hands in the flour by taking the top from a small tin lard can and placing it on top of the flour with its sharp edges down.  When the sieve is shaken, the can top will round up the flour and press it through quickly.  —­Contributed by L. Alberta Norrell, Augusta, Ga.

** A Funnel [7]

An automobile horn with the bulb and reed detached makes a good funnel.  It must be thoroughly cleaned and dried after using as a funnel.

** How to Make Comer Pieces for a Blotter Pad [8]

To protect the corners of blotting pads such as will be found on almost every writing desk, proceed as follows: