The Magic Wand, London, gives the secret of this spirit hand as follows:  The hand is prepared by concealing in the wrist a few soft iron plates, the wrist being afterwards bound with black velvet as shown in Fig. 1.  The board is hollow, the top being made of thin veneer (Fig. 2).  A small magnet, A, is connected to a small flat pocket lamp battery, B. The board is suspended by four lengths of picture-frame wire one of which, E, is

[Illustration:  Wax Hand on Board and Electrical Connections]

connected to the battery and another, D, to the magnet.  The other wires, F and G, are only holding wires.  All the wires are fastened to a small ornamental switch, H, which is fitted with a connecting plug at the top.  The plug can be taken out or put in as desired.

The top of the board must be made to open or slide off so that when the battery is exhausted a new one can be installed.  Everything must be firmly fixed to the board and the hollow space filled in with wax, which will make the board sound solid when tapped.

In presenting the trick, the performer gives the hand and board with wires and switch for examination, keeping the plug concealed in his right hand.  When receiving the board back, the plug is secretly pushed into the switch, which is held in the right hand.  The hand is then placed on the board over the magnet.  When the performer wishes the hand to move he pushes the plug in, which turns on the current and causes the magnet to attract the iron in the wrist, and will, therefore, make the hand rap.  The switch can be made similar to an ordinary push button so the rapping may be easily controlled without detection by the audience.

** Making Skis and Toboggans [3]

During the winter months everyone is thinking of skating, coasting or ski running and jumping.  Those too timid to run down a hill standing upright on skis must take their pleasure in coasting or skating.

The ordinary ski can be made into a coasting ski-toboggan by joining two pairs together with bars without injury to their use for running and jumping.  The ordinary factory-made skis cost from $2.50 per pair up, but any boy can make an excellent pair far 50 cents.

In making a pair of skis, select two strips of Norway pine free from knots, 1 in. thick, 4 in. wide and 7 or 8 ft. long.  Try to procure as fine and straight a grain as possible.  The pieces are dressed thin at both ends leaving about 1 ft. in the center the full thickness of 1 in., and gradually thinning to a scant 1/2 in. at the ends.  One end of each piece is tapered to a point beginning 12 in. from the end.  A groove is cut on the under side, about 1/4 in. wide and 1/8 in. deep, and running almost the full length of the ski.  This will make it track straight and tends to prevent side slipping.  The shape of each piece for a ski, as it appears before bending, is shown in Fig. 1.

The pointed end of each piece is placed in boiling water for at least 1 hour, after which the pieces are ready for bending.  The bend is made on an ordinary stepladder.  The pointed ends are stuck under the back of one step and the other end securely tied to the ladder, as shown in Fig. 2.  They should remain tied to the ladder 48 hours in a moderate temperature, after which they will hold their shape permanently.