An engraved iron mace of the fifteenth century is shown in Fig. 2.  This weapon is about 22 in. long, mounted with an eight-sided or octagonal head.  It will be easier to make this mace in three pieces, the octagonal head in one piece and the handle in two parts, so that the circular shield shown at the lower end of the handle can be easily placed between the parts.  The circular piece or shield can be cut from a piece of wood about 1/4 in. thick.  The circle is marked out with a compass.  A hole is made through the center for the dowel of the two handle parts when they are put together.  A wood peg about 2 in. long serves as the dowel.  A hole is bored in the end of both handle pieces and these holes well coated with glue, the wood peg inserted in one of them, the shield put on in place and handle parts put together and left for the glue to set.  The head is fastened on the end of the handle with a dowel in the same manner as putting the handle parts together.

The head must have a pattern sketched upon each side in pencil marks, such as ornamental scrolls, leaves, flowers, etc.  These ornaments must be carved out to a depth of about 1/4 in. with a sharp carving tool.  If such a tool is not at hand, or the amateur cannot use it well, an excellent substitute will be found in using a sharp-pointed and red-hot poker, or pieces of heavy wire heated to burn out the pattern to the desired depth.  The handle also has a scroll to be engraved.  When the whole is finished and cleaned

[Illustration:  Battle Axes of the Fourteenth, Fifteenth and Sixteenth Centuries]

Up, it is covered with tinfoil in imitation of steel.  The tinfoil should be applied carefully, as before mentioned, and firmly pressed into the engraved parts with the finger tips or thumb.

A French mace used in the sixteenth century is shown in Fig. 3.  This weapon is about 22 in. long and has a wood handle covered with dark red cloth or velvet, the lower part to have a gold or red silk cord wound around it, as shown, the whole handle finished off with small brass-headed nails.  The top has six ornamental carved wings which are cut out, fastened on the handle and covered with tinfoil, as described in Fig. 2.

Figure 4 shows a Morning Star which is about 26 in. long.  The spiked ball and the four-sided and sharp-pointed spike are of steel.  The ball may be made of clay or wood and covered with tinfoil.  The spikes are cut out of wood, sharp-pointed and cone-shaped, the base having a brad to stick into the ball.  The wood spikes are also covered with tinfoil.  The handle is of steel imitation, covered in the middle with red cloth or velvet and studded with large-headed steel nails.

A war hammer of the fifteenth century is shown in Fig. 5.  Its length is about 3 ft.  The lower half of the handle is wood. covered with red velvet, with a golden or yellow cord wound spirally over the cloth.  The upper half of the handle is steel, also, the hammer and spike.  The entire handle should be made of one piece, then the hammer put on the base of the spike.  The spike made with a peg in its lower end and well glued, can be firmly placed in position by the peg fitting in a hole made for its reception in the top of the handle.  Finish up the steel parts with tinfoil.